Clear individual bad jets, View current bad jets, Clear all bad jets for a head – HP Scitex FB700 Industrial Printer User Manual
Page 58
Clear Individual Bad Jets
When you select Clear Individual Bad Jets, the control panel displays the following prompt:
Head 1: Press Proceed (►) to clear a bad jet.
1.
Press ▲ and ▼ to select a head number, then press Proceed (►).
The control panel displays a numeric keyboard that you can use to enter the number of the bad
jet.
2.
Enter the jet number, then press Enter.
3.
When you are finished entering jet numbers, press Cancel.
The control panel displays the head selection message again.
4.
Press ▲ and ▼ to select the next head number, then press Proceed.
5.
Repeat steps 2 through 4 for each head containing bad jets you want to clear.
6.
When you are finished clearing bad jets, press Cancel.
The control panel displays the previous menu.
View Current Bad Jets
When you select View Current Bad Jets, the control panel displays the following prompt:
Head 1: Press Proceed to view bad jets.
1.
Press ▲ and ▼ to select a head number, then press Proceed (►).
The control panel displays a message that lists the bad jets by number.
2.
Press Proceed (►) to return to the head selection screen.
3.
Repeat steps 1 and 2 for each head you want to check for bad jets.
4.
When you are finished viewing bad jets, press Cancel.
The control panel displays the previous menu.
Clear All Bad Jets for a Head
When you select Clear All Bad Jets for a Head, the control panel displays the following prompt:
Head 1: Press Proceed to clear all bad jets.
1.
Press ▲ and ▼ to select a head number, then press ► (Proceed).
The control panel asks you to confirm your selection.
2.
Press ►.
The control panel asks whether you want to clear the hard bad jets as well as the soft bad jets. A
“soft” bad jet is a jet that you believe is temporarily out, based on past performance. A “hard” bad
jet is a jet that you believe is permanently out.
3.
Press ► to clear the hard and soft jets. Press X to clear the soft jets only.
The control panel reports the number of jets that were cleared on the selected printhead.
4.
Press ►.
52
Chapter 7 Calibrate the printer
ENWW