Important operating notes – HP Scitex FB700 Industrial Printer User Manual
Page 8
RIP
The printer receives print jobs from a supported raster image processor (RIP). The RIP is installed
and connected during the printer installation process.
Important operating notes
●
UV CURE INK IS PERISHABLE. Unlike other inks used in wide format printing, UV cure ink has
a limited shelf life. White ink has a six month shelf life from the date of manufacture. Plan to
rotate your ink stock and use it promptly by the date printed on the ink box.
CAUTION:
When the UV lamps are switched off, they undergo a controlled cool-down cycle.
Sudden removal of power from hot lamps, such as disconnecting the power cord or from a power
outage, can result in overheating and permanent damage. The lamps should be switched off only via
the printer software.
●
The media supply may be wound either printed-side-out or printed-side-in, but the takeup must
be loaded printed-side-in.
●
The default head height is set to 2.2 mm (0.085 in) above the media. (The space below the
carriage will measure 1.778 mm (0.070 in) due to the printhead protection frame around the
outside of the carriage.) The head height can be adjusted up or down at the control panel
(Printing page > Options).
●
The Media Wizard stores a set of operational parameters for predefined and user-defined media
types. When you load a new media type, select an existing Media Wizard set, or create a
custom set. Media Wizard parameter sets can be selected at any time from the control panel.
●
Wear cotton gloves when loading media to prevent fingerprints that could show after printing.
You can use a 90% solution of isopropyl alcohol (IPA) to clean fingerprints and reduce static
electricity on synthetic media (allow to dry five minutes before printing).
●
DO NOT reprint over any output that has not completely cured (for example, due to a UV lamp
malfunction).
●
DO NOT rest or store a media roll on end, or you could cause edge creases that could strike the
printheads during printing. To avoid bowing, store sheet-fed media flat, not standing on end.
●
DO NOT set heavy objects on the power cord or printer cable; do not bend the cables or force
them into contorted positions.
●
DO NOT place heavy objects anywhere on the printer.
●
Since automatic head maintenance cannot occur when the printer is powered down, keep the
printer powered on at all times if possible. The printer will enter a power-saving Sleep Mode if
idle for a user-define period of time. If automatic head maintenance does not occur for an
extended period, manual purging may be necessary to restore the printheads to working
condition (see
Startup and check jet health on page 91
). If all power is lost to the printer, ink
will drip from the printheads due to loss of printhead vacuum, collect on the bottom of the
carriage, and drip into the printer or onto the media drive belt. Keep the printer connected to a
UPS to prevent vacuum loss to the printheads (see
).
●
If the printer will be completely powered down for an extended period (such as over a long
holiday period), all printheads should be emptied of ink (see Printhead Procedures under
) and the bottom of the carriage cleaned. To resume printing,
the printheads must be refilled with ink, purged, and restored to working condition. See
and
Startup and check jet health on page 91
2
Chapter 1 Introduction
ENWW