HP StorageWorks XP Remote Web Console Software - Manual (Page 106)

Table 57 Parameters for the FCWITHDR Command (Version 2)
Description Value Parameter
Specify the number (device address) of
the S-VOL on which you want to
perform the FCWITHDR command. Source device number. SDEVN
Specify the number (device address) of
the T-VOL on which you want to
perform the FCWITHDR command. Target device number. TDEVN
Specify the number (device address) of
the device on which you want to Device number. DEVN
perform the FCWITHDR command with
the ACTION parameter.
Specifies the TrueCopy for Mainframe
source device number (device address). TrueCopy for Mainframe source
device number
Use this parameter when REMOTE is
YES.
The relationships established on the
volume specified as the copy source by YES DDSW
SDEVN are withdrawn. The
relationships are withdrawn after the
contents of the volume specified as the
copy target by TDEVN is fixed.
Default setting. The relationships
established on the copy target are all NO
withdrawn. The relationship is not
established when the copy target is
online.
Specifies the extent (the range to
withdraw the relation) for the starting Extents (copy range) XTNTLST
and ending addresses of the source and
the starting and ending addresses of
the target with CCHH. Up to 32 extents
can be specified. When XTNTLST is not
specified, the relationships on all the
tracks are withdrawn.
Resume the write operation from the
host to the volumes that belong to the THAW ACTION
same CU of the device specified by the
DEVN parameter.
Specifies the device number (device
address) of the T-VOL on which you YES TGTUCB
want to perform the FCWITHDR
command. To specify this number, use
the TDEVN parameter. YES is the
default setting.
Specifies the serial number, the CU
number, and the LDEV number of the NO
T-VOL on which you want to perform
the FCWITHDR command. To specify
this number, use the TARGET parameter
instead of TDEVN.
Specifies the serial number, the CU
number, and the LDEV number of the Serial number, CU number, LDEV
number of the T-VOL TARGET
T-VOL on which you want to perform
the FCWITHDR command.
106 Performing Version 2 Operations