HP StorageWorks XP Remote Web Console Software User Manual
Page 124
Table 64 Information Displayed by the FCQUERY Command (Version 2) (continued)
Definition
Displayed content
Displayed item
•
M-VOL of the TrueCopy Asynchronous for Mainframe pair (Timer Type
is SYSTEM or NONE, and the pair status is Duplex or Pending Duplex)
•
P-VOL of the Universal Replicator for Mainframe pair (Timer Type is
SYSTEM or NONE, and the pair status is Duplex or Pending Duplex)
Volume specified by DEVN is not in the status described above, or the
volume is not used.
N
Volume specified by DEVN is currently used as the S-VOL (M-VOL) of the
ShadowImage for Mainframe or TrueCopy for Mainframe pair.
P
PC
Volume specified by DEVN is currently used as the T-VOL (R-VOL) of the
ShadowImage for Mainframe or TrueCopy for Mainframe pair.
S
When system option mode 20 is ON and the REMOTE parameter value of
the TSO command is YES, S is displayed for this item. When system option
mode 20 is OFF, S will always be displayed for this item. For details about
system option mode 20, see the Hitachi TrueCopy™ for Mainframe User
Guide: HP XP24000 Disk Array, HP XP20000 Disk Array.
Volume specified by DEVN is currently not used for ShadowImage for
Mainframe or TrueCopy for Mainframe.
N
When system option mode 20 is ON and when the REMOTE parameter
value of the TSO command is NO, N is displayed for this item. For details
about system option mode 20, see the Hitachi TrueCopy™ for Mainframe
User Guide: HP XP24000 Disk Array, HP XP20000 Disk Array.
Volume specified by DEVN is currently used as the S-VOL of the Concurrent
Copy pair.
S
CC
Volume specified by DEVN is currently used as the T-VOL of the Concurrent
Copy pair or is not used for Concurrent Copy.
N
Displays whether the volume specified by DEVN is Revertible or not. However, because Version
2 does not support this function, N will always be displayed for this item. For details about
Revertible, see the IBM manual.
RV
Displays the Sequence Number. However, because Version 2 does not support this function,
00000000 will always be displayed for this item. For details about Sequence Number, see the
IBM manual.
SEQNUM
Displays that the volume specified at DEVN is a normal volume.
N
S
Not supported other than “N”.
Displays that the volume specified at DEVN is one of the following:
N
E
•
The volume is the source of the relationship, and the target is a normal
volume.
•
The volume is the target of the relationship.
Not supported other than “N”.
NOTE:
If you are not sure if system option mode 20 is ON in your storage system, contact HP technical support. HP
technical support can determine the state of the system mode using your remote support connection.
124
Performing Version 2 Operations