HP Officejet Pro K550 Printer - Manual (Page 44)

14
. If one or both the printhead lights still blink, repeat the cleaning procedure described above for
the printhead which corresponds to the blinking printhead light.
15
. If one or both the printhead lights still blink, replace the printhead which corresponds to the
blinking printhead light.
16
. Wait while the printer initializes the printheads and prints the alignment pages. If the printer does
not print the pages, start the alignment process manually (see
To align the printheads ).
To replace the printheads
NOTE To find out which printheads work with your printer, see Supplies .
1. Open the top cover.
2. If the carriage does not move to the left automatically, press and hold ( Resume button) for 3
seconds. Wait for the carriage to stop moving.
3. Lift the printhead latch.
4. Lift the handle of a printhead and use it to pull the printhead out of its slot.
5. Remove the new printhead from its package, and then remove its orange protective caps.
6. Insert the printhead into its color-coded slot (the label on the printhead must match the label on
the printhead latch). Press down firmly on the printhead to ensure proper contact.
7. Pull the printhead latch all the way forward, and then press down to ensure that the latch is
properly engaged. You might have to apply some pressure to engage the latch.
8. Close the top cover.
9. Wait while the printer initializes the printheads and prints the alignment pages. If the printer does
not print the pages, start the alignment process manually (see
To align the printheads ).
36 Chapter 4 Maintaining and troubleshooting ENWW