Removing a hot-plug sas or sata hard drive – HP ProLiant DL380p Gen8 Server User Manual
Page 56
Advertising
Hardware options installation 56
1.
Remove the drive blank.
2.
Prepare the drive.
3.
Install the drive.
4.
Determine the status of the drive from the drive LED definitions ("
Hot-plug drive LED definitions
" on page
Removing a hot-plug SAS or SATA hard drive
CAUTION:
For proper cooling, do not operate the server without the access panel, baffles,
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
1.
Determine the status of the drive from the hot-plug SAS drive LED combinations ("
" on page
).
2.
Back up all server data on the drive.
Advertising