HP Color LaserJet 4650 Printer series - Manual (Page 185)

Control panel message Description Recommended action
REPLACE TRANSFER KIT
For help press
The transfer unit is at end of life. Printing
will not continue until the transfer kit has
been replaced. 1. Open the top and front cover.
2. Remove the old unit by pressing the
blue buttons on either side of the unit.
3. Slide the old unit out of the printer.
4. Install a new transfer unit.
5. Close the front and top covers.
6. Supplies ordering information is also
available from the embedded Web
server. See
Using the embedded
Web server for more information.
Note
If the old transfer unit was not at end-of-
life when it was replaced (for example, if
it was damaged), or if you want to
continue printing past the end-of-life
message, the transfer unit count must be
reset using the printer control panel.
Please note that the end-of-life message
is provided as a customer service, and
printing past it is likely to result in print
quality degradation in the near future.
Once the transfer kit count has been
reset after an end-of-life message,
feedback on the kit's remaining life will
be incorrect until the kit is replaced and
the count is reset again.
To reset the transfer unit count
1. Press M ENU to enter the MENUS.
2. Press and to highlight
CONFIGURE DEVICE.
3. Press to select CONFIGURE
DEVICE.
4. Press and to highlight RESETS.
5. Press to select RESETS.
6. Press and to highlight RESET
SUPPLIES.
7. Press to select RESET SUPPLIES.
8. Press and to highlight NEW
TRANSFER KIT.
9. Press to select NEW TRANSFER
KIT.
10. Press and to highlight YES.
11. Press to select YES.
The transfer unit count is reset and the
printer is ready to use.
Control panel messages (continued)
ENWW Control panel messages 171