HP Color LaserJet 4650 Printer series - Manual (Page 82)

Setting the link speed
By factory default, the link speed is set to AUTO. Use the following procedure to set a
specific speed:
1. Press to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press to select CONFIGURE DEVICE.
4. Press to highlight I/O.
5. Press to select I/O.
6. Press to highlight EIO X (where X = 1, 2, or 3).
7. Press to select EIO X.
8. Press to highlight LINK SPEED.
9. Press to select LINK SPEED.
10. Press to highlight the desired link speed.
11. Press to select the desired link speed.
12. Press the M
ENU
button to return to the Ready state.
68 Chapter 3 I/O Configuration ENWW