HP Color LaserJet 4650 Printer series - Manual (Page 234)

4. Using a #2 Phillips screwdriver, remove the eight screws holding the board in place, and
set them aside.
5. Slide out the formatter board and set it on a clean, flat, grounded surface.
6. To replace a DDR DIMM that is currently installed, spread the latches apart on each side
of the DIMM slot, lift the DDR DIMM up at an angle, and pull it out.
7. Remove the new DIMM from the antistatic package. Locate the alignment notch on the
bottom edge of the DIMM.
220 Appendix A Working with memory and print server cards ENWW