HP StorageWorks XP Remote Web Console Software - Manual (Page 22)

IMPORTANT:
Disk/cache partitioning for the SVS200 is limited to one SLPR and four CLPRs.
NOTE:
Only the Administrators can create CLPRs.
NOTE:
If you create a CLPR, the default cache size is 4 GB. To create a CLPR, the desired cache size is allocated
from CLPR0 (entire cache).
NOTE:
To create a CLPR, the remaining cache size, which is calculated by subtracting Cache LUN XP Size and
Partial Cache Residence Size from the Cache Size of CLPR0, must be 4 GB or more.
1. Confirm the current CU group in the drop-down list for CU groups at the top of the pane.
NOTE:
To change the CU group, select the desired CU group from the drop-down list for CU groups
in the upper right of the XP Remote Web Console main pane. For more information about
CU groups, see the
HP StorageWorks XP Remote Web Console user guide for XP12000/XP10000/SVS200.
2. Right-click an SLPR in the tree, and select Create CLPR. The CLPR is added to the tree.
3. Select a CLPR in the tree. Information about the selected CLPR appears in the Detail For CLPR
section.
NOTE:
If a CLPR has this icon ( ) and is grayed out, you cannot select the CLPR. To change the
CU group, return to step 1.
4. Change CLPR settings as needed.
5. Click Apply. The progress bar appears.
NOTE:
Even though you clicked Apply, the parity groups have not been allocated to a CLPR yet.
Working with CLPRs 22