HP StorageWorks XP Remote Web Console Software - Manual (Page 31)

NOTE:
You cannot migrate mainframe volumes out of SLPR0. All mainframe volume operations can be performed
by storage administrators, not storage partition administrators.
NOTE:
You can assign a user to an SLPR that has not yet been created. However, if the SLPR does not exist, an
error occurs when that user attempts to launch Command View AE or XP Remote Web Console.
Creating SLPRs
If you have not yet created an SLPR in the array, all of the array's resources (that is, CLPRs and ports)
belong in SLPR0. To divide the array's resources, create a new SLPR in the array.
IMPORTANT:
Disk/cache partitioning for the SVS200 is limited to one SLPR and four CLPRs.
NOTE:
Only Administrators can create SLPRs.
1. Confirm the current CU group in the drop-down list for CU groups in the upper right of the XP
Remote Web Console main pane.
NOTE:
To change the CU group, select the desired CU group from the drop-down list for CU groups
in the upper right of the XP Remote Web Console main pane. For more information about
CU groups, see the
HP StorageWorks XP Remote Web Console user guide for XP12000/XP10000/SVS200.
2. Right-click Subsystem, and select Create SLPR.
NOTE:
To create multiple SLPRs, repeat step 2.
3. Select an SLPR from the tree (see Figure 5 ).
NOTE:
If an SLPR has this icon ( ) and is grayed out, you cannot select the SLPR. To change the
CU group, return to step 1.
XP Disk/Cache Partition user guide 31