HP StorageWorks 2300 Disk System - Manual (Page 139)

Removal and Replacement 139
Re
m
ova
l a
nd
R
epl
a
ce
m
ent
5 Rotate the disk system and place it on the back end of the disk system. The
empty disk module slots should be facing up.
6 Align the end cap tabs into the appropriate slots at the top of the disk system.
7 Rotate the end cap down over the base, aligning the small tabs at the top of
the end cap with the end cap slots. Insert and tighten the M5 retaining screws
using the Torx T25 driver. Be sure the retaining screw holes are aligned (see
Figure 67).