Figure 30 – HP StorageWorks 2300 Disk System User Manual
Page 61
Advertising
Installation
61
In
st
al
la
ti
o
n
7. Install clipnuts on the front columns of the cabinet (see
).
These are used for the device retention screws.
8. Place the storage device on the rails and slide it into the cabinet until
the retention bracket comes in contact with the rack column (see
WARNING
An empty storage device weighs approximately 54 pounds
(without disk modules installed) (24.5 kg). To avoid personal
injury, it is recommended that two people install the storage device
in the rack.
Advertising