HP StorageWorks 2300 Disk System - Manual (Page 70)

70 Installation
Install the Disk System
1. Remove the power supply/fan modules to prepare the disk system for lifting:
a Loosen the screws in each extractor handle of each power supply/fan
module with the chassis still in the box.
b Pull the extractor handles out from the center of the power supply to
disengage the it from the midplane. Pull each power supply/fan module
out of the chassis. Support the far end of the power supply/fan module
with your free hand as it clears the chassis.
c Set the power supply/fan module aside, on an antistatic pad, to be
reinstalled later.
WARNING Do not attempt to lift the disk system without the help of another
person or a lift device. Even without power supplies and disk
drives, the disk system weighs 54 pounds.
2. Remove the disk modules from the disk system. Place them aside on
the pink anti-static foam pad supplied with your disk system.
3. Carry the disk system to the front of the rack and slide the back end
onto the rails ( Figure 38 ) with the help of another person or using a
lifting device. Push the disk system into the rack as far as it will go.
4. Secure the disk system as appropriate for the rail kit and cabinet at the
installation site.