HP Hitachi Dynamic Link Manager Software - Manual (Page 146)

3. Creating an HDLM Environment
124
#
Name of the node being used.
6. Stop HACMP on the active host.
Specify takeover as the shutdown mode.
7. Migrate HDLM on the active host.
To do so, perform steps 10 to 26 in 3.5.6 Migrating from HDLM Version 5.8.1 or
Earlier to Version 5.9 or Later on the active host.
8. Start HACMP on the active host.
When HACMP starts, a warning message may be output, stating that the custom
disk method file (
/usr/DynamicLinkManager/cluster/
dlm_hacmp_gdisk_check
) does not exist. This message can be ignored
because it does not affect any operations.
The following is an example of such a message:
WARNING: Custom disk method: ghostdisks's file:
/usr/DynamicLinkManager/cluster/dlm_hacmp_gdisk_check does
not exist or is not executable on node:
xxx #
#
Name of the node being used.
If this warning message is output, proceed to step 9. If it is not output, proceed to
step 12.
9. While HACMP is running, delete the custom disk method defined in 5.8.1 or
earlier, or in 5.9 or later.
10. Add an HDLM custom disk method.
11. Synchronize the cluster resources.
12. Delete the custom disk method.
To do so, perform the procedure described in 3.14.5 Canceling Cluster Software
(HACMP) Settings on the active host.
13. Configure a custom disk method.
To do so, perform the procedure described in 3.10.2 Registering the HDLM
Script for HACMP on the active host.
14. If you deleted the disk heartbeat settings in step 2, re-configure the disk
heartbeats.
For details, see the HACMP documentation.