HP Hitachi Dynamic Link Manager Software - Manual (Page 492)

B. Differences Between HDLM Version 5.9 or Later and Version 5.8.1 or Earlier
470
B.2 Simplifying the HDLM Environment Configuration and
Operation Procedures by Changes to the Logical Device Files
„ The logical device files that can be controlled by the HDLM driver have been
unified from HDLM devices (
dlmfdrv
n) to the hdisk provided by the OS.
Therefore, logical device files controlled by HDLM can be configured by AIX's
standard
cfgmgr
command.
Both the file that defines non-HDLM-managed disks (
/usr/
DynamicLinkManager/drv/dlmfdrv.unconf
) and the file that defines the
HDLM driver configuration (
/usr/DynamicLinkManager/drv/
dlmfdrv.conf
) are no longer used. After installing HDLM, all devices shown
in Devices that HDLM can manage in 2.1 Devices Managed by HDLM will be
managed. You cannot exclude physical volumes from HDLM-managed targets.
Accompanying these changes, the following deletions have been made from the
manual HiCommand Dynamic Link Manager User's Guide (for AIX(R))
(3000-3-926-50(E)):
• 2.5.1 Logical Device Files for HDLM Devices
• 3.3.4 Notes on HDLM devices
• 3.3.10 Notes on the system configuration change
• 3.8 Setting up volume groups
• 3.9.4 Setting the clconraid.dat file
• 3.9.5 Notes on HACMP
(1) When executing HACMP C-SPOC (Cluster-Single Point of Control)
commands
(3) Disk heartbeat
• 3.10 Settings for using GPFS
• 3.15.7 Deleting the HACMP settings
(1) Deleting a user-defined cluster event
• 4.1.6 Error checking for physical volume (hdisk) specification operations
• 4.1.7 Changing the attributes of HDLM management-target devices
• 4.1.8 Notes on configuring an HDLM device
• 4.1.9 Notes when the physical volume and HDLM device are placed in a
defined state
• 4.1.10 Notes on changing the disk configuration
• 4.1.13 Notes when the SMIT window is used