HP ProLiant DL388e Gen8 Server - Manual (Page 43)

Hardware options installation 43
c. Connect the SATA cable to the rear drive cage, secure the cable in the cable clip, and then connect
the cable to the system board.
d. Install the primary PCI riser cage (" Install the PCI riser cages " on page 25 ).
10. If you are not installing the secondary PCI riser cage, then install the secondary PCI riser cage blank.
11. Connect the rest of the drive cables required in this drive configuration. For more information, see
"Storage cabling (on page
81 )."
12. Install the drives (" Installing a hot-plug drive " on page 36 ).
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
13. Install the access panel (on page 23 ).
14. Install the server into the rack (" Installing the server into the rack " on page 32 ).
15. Power up the server (on page 19 ).