HP ProLiant DL388e Gen8 Server User Manual
Page 56
Advertising
Hardware options installation 56
5.
Install the fan module into the fan bay.
6.
Install the access panel (on page
7.
Slide the server back into the rack.
8.
If the fan installation was made to upgrade the server from a nonredundant to a redundant fan mode,
reboot the server.
Installing the hot-plug fan module if the server is installed in a
friction rail system
1.
Power down the server (on page
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Remove the server from the rack (on page
4.
Remove the access panel (on page
5.
Do one of the following:
Advertising