HP SAN Virtualization Services Platform - Manual (Page 236)

3. Either:
a. Right-click the PiT to which you want to roll back a virtual disk, VDG, or VDG snapshot.
b. Select Manage > Rollback PiT. The Rollback PiT wizard opens to a confirmation screen.
or:
a. Right-click the virtual disk, VDG, or VDG snapshot that you want to roll back.
b. Select Manage > Snapshot Service > Rollback. The Rollback wizard opens to the Select PiT
screen.
Figure 49 Rollback wizard—Select PiT screen
.
c. In the upper area of the screen, select the PiT to which you want to roll back the virtual disk,
VDG, or VDG snapshot.
d. Click Add. The PiT appears in the lower area of the screen. If you want to undo your selection,
select the PiT in the lower area and click Remove.
e. Click Next. A confirmation screen appears.
4. Read the confirmation screen and make sure that you want to perform the operation described.
If necessary, click Cancel to cancel the rollback, or click Back to return to the previous screen
and change your PiT selection.
5. Click Finish.
6. Select the virtual disk in the virtual disks list, or the VDG in the VDGs list, or the VDG snapshot
in the VDG Snapshots list.
7. Select the Hierarchy tab or PiT tab in the tabs area below the list.
8. Verify that all PiTs were removed as expected.
9. Remount the virtual disk, VDG, or VDG snapshot on the host.
10. Restart the host application that was using the virtual disk or VDG.
Using snapshots 236