GE ZBD9900RII - Manual (Page 12)

12
1. Loosen the mounting screws on the dishwasher’s
two front steel feet using a 5/8 inch (16mm) open-
ended wrench. Screw the mounting screws down
as close to the floor as possible.
2. Adjust the height of the dishwasher by turning
the front steel feet with your hands. Leave enough
space to adjust them later.
LEVEL DISHWASHER
IMPORTANT
– Dishwasher must be level for proper
dish rack operation, wash performance and door operation.
The dishwasher must be leveled left to right and front to back.
This assures the dish racks will not roll in or out on their own,
circulation water will flow to the pump inlet, and the door will
close without hitting the side of the tub.
• Remove the lower dish rack and place a level on the door and
lower rack track.
• Adjust the level of the dishwasher by individually turning the
four legs on the bottom of the dishwasher.
• The dishwasher is properly leveled when the level indicator is
centered left to right and front to back. Also, the dishwasher
door should close without hitting the side of the tub.
• Replace the lower rack.
Tip: Prevent unnecessary service charges. Verify dishwasher
is leveled.
Pull the dish racks half way out . They should stay put. Open
and close the door. The door should fit in the tub opening
without hitting the side of the tub. If the racks roll on their own,
or the door hits the side of tub, re-level the dishwasher .