GE ZBD9900RII - Manual (Page 6)

6
CORNER INSTALLATION
If the dishwasher is installed in a corner, there must be a mini-
mum clearance of 2” (50 mm) from the side wall so the door
can open.
2” clearance
At this point the styrofoam, plastic wrap, and the wood pallet
(base) should be removed from the dishwasher. Now is an
excellent time to inspect for any shipping damage. Should you
find any damage, you should report it to your dealer or builder
immediately.
Be sure to remove the toe kick and toe kick insulation (only on
certain models) from the top of the dishwasher.
SLIDES FOR LEGS
The unit comes with white plastic slides for
the legs to protect the kitchen floor from being
damaged when you slide the unit into place.
The slides simply snap onto the bottom of the
legs.
Protective slides for legs simply snap onto the
bottom of the legs.
PREPARING THE DISHWASHER FOR INSTALLATION
ADJUSTING THE DOOR SPRINGS
Before you install the unit into the cabinet, open the door
to make sure it stays open at any
angle. If it tends to fall down or
snap shut, pull out the machine and
tension the door springs on the sides
of the machine by moving them
one hole farther back or by twisting
the spring to make it shorter. The
accessory door panel or custom
wood panel must be installed on FI
dishwashers to properly adjust tension on the door springs. If
that doesn’t resolve the problem, you may need to purchase
the heavy-duty door springs (part number WD01X10445).
NOTE:
If the door panel weighs more than 15 pounds, you may need
to order the heavy-duty door springs. (See page 5.)
Shorten