ASKO T761 - Manual (Page 21)

Page 21
ENGLISH
ENGLISH
T761 AND T781 ERROR MESSAGES
Error messages will display in the LCD window if a fault
occurs while a program is in progress. The table below
defines each possible error message. If the message still displays after you have checked the possible
solutions, call a service technician.
ERROR MESSAGE SOLUTION
Maximum program time
Overflow (T781)
Sensor
Thermistor
Make sure both fuses are intact.
Clean the lint filter.
Make sure exhaust hose is clear (T761).
Clear message by turning the power off then on.
Make sure the condensed water container is empty. If draining into a drain pipe,
make sure the black rubber hose is not kinked or blocked. The drain should not be
higher than 40 inches from the floor.
Make sure the condensation pump is not blocked.
This can appear if there are dry clothes in the drum when the unit is started. Cancel
the error message by opening the door or turning the power off then on.
Call a service technician.
♦
English
♦
French
♦
Spanish
♦
Portuguese
♦
Italian
♦
German
♦
Swedish
♦
Danish
♦
Norwegian
♦
Netherlands
♦
Finnish
CHANGING THE LANGUAGE ON
THE LCD DISPLAY
There are eleven languages available for the LCD
window:
To change the language, follow the steps below:
1. Turn the machine off then on again.
2. Press
ENTER
five times in succession then press
P1 five times. (This must be done within 15 seconds.)
3. When the Language menu displays, press an
Arrow
button to advance through the menu to the desired
language.
4. Once the correct language displays, press ENTER
to program the LCD window to display the language
you selected.
CHILD-SAFE START
As a safety measure, you can program the T761 and
T781 not to start unless the Start button is held down
for three seconds. To do this, follow the steps below:
1. Turn the machine off then on.
2. Press
ENTER
five times, then press
P3
five times.
(This must be done within 15 seconds.)
3. “Delayed start” displays with “0” flashing in the lower
right corner. Press the Right Arrow button to toggle
the display to “3.”
CHILD-SAFE MENU BUTTON
Please note that when you set the child-safe Start button,
the Menu button is automatically programmed to delay
for three seconds before it becomes active. This prevents
a child from accidentally changing the program settings.
When you want to change a program, press the Menu
button for three seconds to activate the menus. The
Menu button will work normally (without the 3-second
delay) until you have completed your changes. If it is
not pressed for two minutes, it will automatically revert
back to the child-safe mode.