ASKO T761 - Manual (Page 23)

Page 23
ENGLISH
ENGLISH
CLEANING THE CONDENSER-
T721 AND T781
The condenser should be cleaned on a regular basis,
preferably monthly. If you have pets, you should probably
clean it more often. To clean the condenser, follow the
steps below:
1. Turn off the main power to the machine.
2. Remove the two 20-torx
screws on the bottom of
the front panel then grasp
the bottom of the panel and
pull it forward and down.
3. Turn the levers on the
condenser cover counter-
clockwise to release it then pull
it down.
4. Pull out the condenser.
5. Spray the filter with warm
water until all of the lint is
removed.
6. Make sure the side marked
“UP” does face up and carefully
replace the condenser into the
unit.
7. Close the condenser cover.
8. Replace the front panel.
9. Turn back on the main power.
WARNING!
Do not put the condenser
into a dishwasher. Do not
use any sharp metal objects or
a wire brush to clean the
condenser. Also, do not poke
anything between the fins.
1. Turn off the main power to the machine.
2. Remove the two 20-torx
screws on the bottom of
the front panel then grasp
the bottom of the panel and
pull it forward and down.
3. Unscrew the two 10-torx safety
screws (A) on the bottom of the
fan cover and fold out the four
tabs (B).
4. Remove the fan cover.
5. Hold the fan in place while you
unscrew the nut.
6. Pull out the fan and clean it
with a brush and water.
7. Replace the fan and screw the
nut securely.
8. Replace the fan cover and fold
the lugs back into place.
Replace the safety screws.
9. Replace the front panel.
10. Turn back on the main power.