American Fibertek Commander C10e/C10e-I/C10p/C10p-I - Manual (Page 103)

103
Default Settings
Commander is programmed with several default settings. The default settings are designed to
help you limit your programming to only functions and features that are specific to your
operation. Please note, Commander cannot be operated with only its in Default settings in place.
Commander is designed to operate in the specific environment that you assign.
It is strongly suggested that once you have completed your programming, you save you
configuration. If programming is lost for any reason you can easily restore it. Commander is
designed to maintain its programming memory in the event power is lost.
Start Up:
Upon entering the user name and password Commander will default to the Status View screen.
The program modes displayed on the viewer screen left side will be determined by the security
level assigned to the user name.
The default password for the default user names: Admin, ITAdmin, and SecAdmin, is
"Password”. User names and passwords are case sensitive. A user name is limited to 10
characters. The password is limited to 8 characters. Below is a summary of default parameters.
Temperature F
Warning alarm delay
4 hours
Sensor status Off
Network Settings:
IP Address: 192.168.0.246 (Before firmware 20110504: 192.168.10.11)
Net Mask: 255.255.255.0
Gateway: 192.168.0.143 (Before firmware 20110504: 192.168.10.1)
DHCP Disable
DNS Disable
Port Communications:
Auto
Probe Names:
If a probe has not been provided a name, it will not appear in any viewing functions.
The system will only display the number of probes that are actually connected to Commander.
If a probe is not connected to Commander it will not be displayed in the tree or show up in any
programming function. When a probe is connected to Commander the probe ID number will
automatically be registered. The probe ID will serve as the probe name until a new name is
provided by the operator. Probe names are stored in the Probe, limiting their names to 16
characters.