American Fibertek Commander C10e/C10e-I/C10p/C10p-I - Manual (Page 20)

20
Resetting Commander’s using the RS 232 Port
In some cases it maybe necessary to reset Commander using the RS 232 Port in order to recover
from incorrect IP settings.
!
To reset the RS232 Port:
Connect to the RS232 port with a Null Modem cable.
Set the computer’s terminal program to 115200/8/N/1.
Push the reset button for 4 seconds.
The Port B Led will go Orange when the button is pressed and then Red after the 4 seconds.
The following login will appear:
¾ AFI Commander Linux
¾
¾ Commander login: root
¾ Password: (not required)
¾ Enter the recovery user name
The unit will list the current system time and IP Address with a menu:
>
¾ Wed Nov 15 15:34:02 EST 2006
¾
192.168.10.11
¾ >
The settings are as follows:
>
0) Dump current setting
1) Disable Firewall, allow all IPs
2) Set IP to 192.168.10.11
9) Exit
Select:
Selecting 0 will dump the current status of the Commander device for advanced troubleshooting.
Selecting 1 will disable the firewall until it is set via the web interface.
Selecting 2 will set the IP Address back to the default settings without resetting any other
parameters.
Selecting 9 will set the serial port settings back to default.