American Fibertek Commander C10e/C10e-I/C10p/C10p-I - Manual (Page 42)

42
NTP
Commander provides three different NTP
settings:
None: NTP is not active. Commander’s internal
real time clock is used as the reference. When
using the internal clock as reference, please
make certain the time is correct.
Accept NTP Broadcasts: Commander will accept NTP broadcasts. Use this setting if you are
using a system clock.
Poll NTP Server: Commander will Poll a NTP Server at a specific IP address. This setting can be
used to poll at external NTP source located on the Internet.
Accept NTP Broadcast
If you want Commander to accept NTP Broadcasts, clock the button and Save. A pop up will ask
you to confirm your selection. Click OK to accept and Cancel to return to the previous screen.
If Commander accepts the update, it will issue a
pop up. Click OK to return to the previous
screen
Poll NTP Server
If you want Commander to Poll an NTP Server,
begin by confirming the location and access to
the server. Enter the NTP IP Server Address.
Next
program the duration you want
Commander to poll the time server.
Finish by clicking “Save”.
Poll NTP Server Setting Saved
If you want Commander to Poll an NTP Server,
begin by confirming the location and access to
the server. Enter the NTP IP Server Address.
Next program the duration you want
Commander to Poll the server. Finish by
clicking Save.
Poll NTP Server Setting Saved
When Commander has accepted the changes it
will issue a pop up. Click OK to accept.