Clinton Electronics CE-20PVMDVR User Manual - Manual (Page 12)

12
Settings
Settings can be made using the 5 button OSD Board located on the under side of the door.
1. Press the SET button to activate On-Screen SETUP Menu
2. Select the function you wish to adjust using the UP or DOWN button.
3. When the LEFT or RIGHT button is pressed, the available modes are displayed (*Note: Some
menu selections may not have multiple modes to select). Keep pressing the button until you get
the mode you wish to operate.
4. Press SET to enter the value settings (if applicable) and adjust as necessary with the LEFT and
RIGHT buttons.
5. Press SET to apply the value, and exit the current value settings screen.
6. Repeat steps 2-5 to adjust the appropriate settings.
4. Select EXIT from the menu selections, and then press the SET button to exit the SETUP menu.
UP
RIGHT LEFT
DOWN SET