Clinton Electronics CE-20PVMDVR User Manual - Manual (Page 17)

17
Special
1. Position the arrow to point to SPECIAL on the SETUP
menu by using the UP or DOWN button.
2. Enter the SPECIAL options menu by pressing the
SETUP button.
CAMERA ID: Use this function to input the
camera’s ID/name and have it appear on the
monitor.
• If “OFF” is selected, the ID/name does not appear on the monitor even if it has been entered.
1. Position the arrow to point to CAMERA ID by
using the UP or DOWN button.
2. Select ON by pressing the LEFT or RIGHT button.
3. Press the SET button to enter the ID menu.
4. Use the UP, DOWN, LEFT, and RIGHT buttons to
navigate to desired characters, and press SET to enter.
You can enter up to 15 characters.
• If the wrong name has been entered....
If you press the SET button after moving the cursor to CLR, all characters will be erased.
If you wish to correct a single character, move the cursor to the arrow at the bottom left of the screen,
and press SET as many times as needed until the cursor is over the character you wish to replace.
Next, position the cursor above the character you wish to replace it with, and press SET.