Clinton Electronics CE-PTZ-KEY - Manual (Page 16)

16
Basic Operation-
Initial Screen and Self-Testing
After powered on, the dome starts the self-testing by slowly rotating and panning. After the self-
test completes the initial information will be displayed on the screen.
Open the On-Screen-Display (OSD) Menu
This dome supports OSD menu for simple configuration of device settings. To enter the OSD
menu, press [shot] 95 [enter] on the keyboard. Or call the sequence [shot] 9 [enter] twice within 3
seconds. If you encounter troubles, make sure your keyboard settings are correct for the camera
you are trying to control, such as the CAM number on your keyboard matching the number
assigned to the desired PTZ.
Navigation from keyboard
[IRIS OPEN] Enters the sub menu or confirms a setting
[IRIS CLOSE] Exits the selected menu item or cancels the current setting.
[UP], [DOWN] Move between menu lines, or adjust the selected value.
[RIGHT] Enter a highlighted menu item. (same as [IRIS OPEN])
[LEFT] Moves left or exit the menu item.
The initial information will remain on
the screen until a button is pressed,
joystick is moved, or until “POWER UP
ACTION” initiates. See next page on
how to show Initial Info within system
settings menu, and how to define
Power up action.
MAIN MENU
- - - - - - - - - - - - - - - - - -
SYSTEM SETTING -->
CAMERA SETTING -->
FUNCTION SETTING -->
WINDOW BLANKING -->
EXIT
S/N:XXXXXXXXXXXXXXX
CLINTON V2.42
PROTOCOL: CLINTON
DOME ADDRESS: 001
COMM 9600, N, 8, 1
S/N of the PTZ
Software Version
Protocol
Dome ID
Communication
Parameter
EDIT DOME LABEL
- - - - - - - - - - - - - - - - - -
LABEL: DOME 1
BACK
EXIT
EDIT DOME LABEL
For multiple domes in a single installation, it may be helpful to assign a name to
every dome with location info. Label may contain alphanumeric values up to 16
characters long. Ensure Dome Label is set to “ON” ; see Display Setup on pg.12.
- Enter OSD and select SYSTEM SETTING
- Select EDIT DOME LABEL and enter the sub menu
- Select LABEL and enter with [RIGHT] or [IRIS OPEN]
- The input character starts to flash, use [UP] or [DOWN] to select the desired
character and [RIGHT] for next input.
- Available characters appear in the following order: “0” to “9”, “A” to “Z”, “:” , “<” ,
“>” , “-”, {SPACE}
- Use [LEFT] to move to previous character if needed.
- If you need to delete a character, use the {SPACE} character.
- When finished, press [IRIS OPEN] , or use [RIGHT] to move to last
character and then navigate to BACK or EXIT to exit the editing mode.
- Select “BACK” to exit to “SYSTEM SETTING” menu.
System Settings
SYSTEM SETTING
- - - - - - - - - - - - - - - - - -
EDIT DOME LABEL -->
INITIAL INFO -->
DISPLAY SETUP -->
MOTION -->
CLEAR -->
PASSWORD SETUP -->
CLOCK SETTING -->
COMM SETTING -->
BACK
EXIT