Clinton Electronics CE-PTZ-KEY - Manual (Page 20)

20
In the function settings, user can setup the automated PTZ functions, such as
preset position, tours, scan, etc. These functions may become very useful for
your surveillance application.
PRESET
Preset point is a position of PTZ which can be memorized by the device and be
recalled immediately, if needed. Up to 128 preset points are supported. Quickly
recall a preset using the keyboard by pressing “SHOT”, the desired preset #,
then “ENTER”. *NOTE: Assigning #95 to a preset will result in an error, as this
number is used to call up the System Settings OSD Menu.
[PRESET NUMBER]: Selected preset position
[SET PRESET]: Setup the preset position. Enter this menu, move the PTZ to
desired position, and press [IRIS OPEN] to store, or [IRIS CLOSE] to discard.
[SHOW PRESET]: This will show the current preset defined in [PRESET NUMBER]
[CLEAR PRESET]: This will delete the current preset defined in [PRESET NUMBER]
[EDIT PRESET LABEL]: Assign a name to the current preset position defined in
[PRESET NUMBER]. This label will show on the screen when called up. “Preset
Label” must be set to “ON” for label to appear on-screen. See pg 12; “Display
Setup”.
[BACK]: Move to previous screen (doing so will save your changes to presets)
[EXIT]: Exit the OSD (doing so will save your changes to presets)
MAIN MENU
- - - - - - - - - - - - - - - - - -
SYSTEM SETTING -->
CAMERA SETTING -->
FUNCTION SETTING -->
WINDOW BLANKING -->
EXIT
FUNCTION SETTING
- - - - - - - - - - - - - - - - - -
PRESETS -->
SCAN -->
PATTERNS -->
TOUR -->
ZONES -->
TIME RUNNING -->
BACK
EXIT
PRESETS
- - - - - - - - - - - - - - - - - -
PRESET NUMBER 001
SET PRESET -->
SHOW PRESET
CLEAR PRESET
EDIT PRESET LABEL -->
BACK
EXIT
Function Settings