Clinton Electronics CE-PTZ-KEY - Manual (Page 22)

22
TOUR
A Tour is an automated cruising through selected preset positions with individual
speed settings and dwell times. This PTZ supports up to 4 tours with 24 positions
each. *NOTE: Before a tour can be properly set up, you must first define your
preset points you wish to include in the tour (see page 16 “Presets”).
A tour sequence will repeat until interrupted by a movement of the joystick
after it reaches a preset point, or until another command is entered (ie.
[SHOT]95[ENTER] to enter menu).
[TOUR NUMBER]: Current tour number
[EDIT TOUR]: Edit the current selected tour as defined in [TOUR NUMBER]
Tour Editing:
PO: The preset position being included in the tour. If there is no preset
position stored, please exit, and define presets before continuing.
S: The speed in which the PTZ moves to this preset. The value is between
1(slow)-8(fast).
TM: The dwell time before the PTZ moves to the next point. Given in
seconds. (Up to 60 sec.)
[RUN TOUR]: This will run the current tour defined in [TOUR NUMBER]
[CLEAR TOUR]: This will erase the current tour defined in [TOUR NUMBER]
[BACK]: Move to previous screen (doing so will save your changes to tour)
[EXIT]: Exit the OSD (doing so will save your changes to tour)
ZONES
The zone function allows user to define a perimeter with a name tag. The
perimeter is defined by setting a Left, and Right end of a desired area. When the
camera enters this area, the name will be displayed on the screen, which provides
better orientation in surveillance applications. Up to 8 zones are supported. Make
sure “Zone Label” is set to “ON” in Display Setup; see pg12.
[ZONE NUMBER]: Current zone number
[SET LEFT LIMIT]: Define the left point of the zone
[SET RIGHT LIMIT]: Define the right point of the zone
[CLEAR ZONE]: This will erase the current zone defined in [ZONE NUMBER]
[EDIT ZONE LABEL]: Assign a name to the current zone defined in [ZONE NUMBER]
[BACK]: Move to previous screen (doing so will save your changes to zones)
[EXIT]: Exit the OSD (doing so will save your changes to zones)
ZONES
- - - - - - - - - - - - - - - - - -
ZONE NUMBER 001
SET LEFT LIMIT -->
SET RIGHT LIMIT -->
CLEAR ZONE
EDIT ZONE LABEL -->
BACK
EXIT
TOUR
- - - - - - - - - - - - - - - - - -
TOUR NUMBER 001
EDIT TOUR -->
RUN TOUR
CLEAR TOUR
BACK
EXIT
EDIT TOUR
PO-S-TM PO-S-TM PO-S-TM
00-0-00 00-0-00 00-0-00
00-0-00 00-0-00 00-0-00
00-0-00 00-0-00 00-0-00
00-0-00 00-0-00 00-0-00
00-0-00 00-0-00 00-0-00
00-0-00 00-0-00 00-0-00
00-0-00 00-0-00 00-0-00
00-0-00 00-0-00 00-0-00
BACK
EXIT