Clinton Electronics CE-PTZ-KEY - Manual (Page 18)

18
CLEAR
The CLEAR function resets the stored settings and controls back to factory default.
*NOTE: Pressing Right with the joystick will activate the following functions.
There are no sub menus to these functions. You cannot undo the action.
[CLEAR ALL ZONES]: Clear set zones
[CLEAR ALL PRESETS]: Clear all stored preset positions
[CLEAR ALL PATTERNS]: Clear all stored pattern tours
[CLEAR ALL TOURS]: Clear all tours
[CLEAR ALL WINDOWS]: Clear all privacy masking settings
*[FACTORY DEFAULTS]: Reset all settings and return to factory settings
[RESTART]: Restarts the system, used after resetting factory defaults
[BACK]: Move to previous screen
[EXIT]: Exit the OSD
*NOTE: After using the FACTORY DEFAULTS option, all system settings and
stored information, such as presets, tour, or patterns will be permanently
erased. Please make sure this is your intention before selecting this option.
PASSWORD SETUP
In password-settings menu, you can change the password, and enable/disable the
password protection function. The password function can prevent unauthorized
access to the OSD and changes to the settings. It consists of a 6 digit number from
0-9, and can be disabled if so desired.
1. To modify the password, you must input the old password. The default
password is 000000.
2. Enter a new password.
3. Enter the new password again in [CONF PASSWORD] to confirm.
To set the password, move left/right to select a digit, and up/down to change the
number. When finished, press [IRIS OPEN] on the keyboard, or move the cursor
right to save the settings.
A “SUCCESS” message will appear on screen when changes are saved, or your
submission is correct. An “ERROR” message will appear on screen when an incorrect
password is entered.
PASSWORD SETUP
- - - - - - - - - - - - - - - - - -
OLD PASSWORD : ******
NEW PASSWORD : ******
CONF PASSWORD: ******
ENABLE PASSWORD OFF
BACK
EXIT
CLEAR
- - - - - - - - - - - - - - - - - -
CLEAR ALL ZONES
CLEAR ALL PRESETS
CLEAR ALL PATTERNS
CLEAR ALL TOURS
CLEAR ALL WINDOWS
FACTORY DEFAULTS
RESTART
BACK
EXIT