EOTech ATPIAL (AN/PEQ-15) - ADVANCED TARGET POINTER ILLUMINATOR AIMING LIGHT - Manual (Page 44)

2-22
2.9 MODE ACTIVATION (Continued)
The cables may then be plugged into the remote jacks of two
separate devices. The smooth Activation Button
corresponds to the cable with the raised, black plug end.
The embossed Activation Button corresponds to the cable
with the recessed, gray plug end (see Figure 2-14).
Figure 2-14. DBR Activation Buttons.
2.10 USING THE AIM LASERS
Modes of operation for the Visible and IR Aim Laser are
selected and activated as described in sections 2.8 and 2.9,
respectively.
Aim Neutral Density / Opaque Lens Cap
Under certain operating conditions, particularly at night, it
may be desirable to prevent inadvertent emission of visible
laser energy. The Aim Neutral Density / Opaque Lens Cap
is provided for this purpose. It also reduces scatter from the
IR Aim Laser. To use the lens cap, stretch it out and over
the front of the Aim Laser exit ports so that it is snug and
firmly in place. See Figures 2-15 and 2-16.