EOTech ATPIAL (AN/PEQ-15) - ADVANCED TARGET POINTER ILLUMINATOR AIMING LIGHT - Manual (Page 58)

3-8
3.3 CORRECTIVE MAINTENANCE (Continued)
Replacing Aim Neutral Density / Opaque Lens Cap or
Pattern Generator
1. If applicable, pull both retaining straps off the Lens Cap
attachment points. Attachment points are located on both
the top and bottom sides of the ATPIAL housing.
Figure 3-4. Lens Cap Attachment Points.
2. Examine the replacement lens cap. Note that one side is
flat and the other side is contoured. Also note that one of
the filters is glossy (Neutral Density) while the other is dull
(opaque).
3. Ensuring the flat side of the new lens cap will face out,
position the lens cap over the Aim Lasers as shown in
Figure 3-5. The glossy, Neutral Density filter must be
aligned with the IR Aim Laser.
ATTACHMENT
POINTS