Alpine VPA-B222R - Manual (Page 13)

12
-EN
01GB05VPAB222R.fm
ALPINE VPA-B222R 68-02065Z87-A (EN)
Setting the bass level
You can boost or cut bass frequencies.
(The audio source level can be adjusted.)
Setting item: LEVEL
Setting level: -7 to +10
Setting the slope
Select the frequency you want to set within the available range.
(Common to each audio source.)
Setting item: SLOPE
Setting range: 0.50
0.75 1.00 1.25
Setting the bass centre frequency
The displayed bass frequency is boosted.
(Common to each audio source.)
Setting item: FREQUENCY
Setting range: 60Hz
80Hz 100Hz 120Hz
• Adjustment cannot be performed when an external audio processor is
connected and DEFEAT is set to ON.
Adjust the subwoofer output.
Setting item: SUBW LEVEL
Setting range: 0 to 15
• The level adjustment becomes available when ON is set in
“Subwoofer On and Off” (page 19).
Loudness introduces a special low- and high-frequency emphasis at low
listening levels. This compensates for the ear's decreased sensitivity to
bass and treble sound.
Setting item: LOUDNESS
Setting range: ON / OFF
• Adjustment cannot be performed when an external audio processor is
connected and DEFEAT is set to ON.
By setting Defeat ON, previously adjusted settings of BASS and
TREBLE will return to the factory defaults.
Setting item: DEFEAT
Setting range: ON / OFF
The volume level of the speaker input voice and the navigation interrupt
voice output from the external audio processor is adjusted.
Setting item: GUIDE MIX LV
* Setting range: 0 to 15
* Make sure to adjust this setting to 15. Otherwise operation may not
be correctly performed.
• Adjust the speaker input voice interruption level in “Adjusting the
Speaker Input Voice Interruption Level” (page 17)and “Navigation
Audio Interruption Volume Adjustment” (page 18).
Rear Entertainment Function
The rear entertainment function independently routes different sources
to the front and the rear inside a car. For example, while listening to the
radio or other audio source in the front, DVD can be enjoyed in the rear
with the optional rear monitor and headphones.
To connect the rear monitor, the optional expansion box VPE-S431 is
required.
1
Press and hold TA/RTN/SETUP for at least 2
seconds.
The SETUP screen is displayed.
2
Press the joystick up or down to select REAR
SELECT, then press the joystick right.
The REAR SELECT screen is displayed.
Display Example for REAR SELECT screen
• This function cannot be used when MONITOR-1 or 2 is set to
OFF in SYSTEM SETUP.
3
Press the joystick up or down to select the desired
external monitor.
4
Press the joystick left or right to set the desired
video source (external input).
5
Press TA/RTN/SETUP to return to the previous
screen. Press TA/RTN/SETUP repeatedly to return
to the main source screen displayed before starting
the setup operation.
• To cancel the rear entertainment function, set to OFF.
• When the “Setting the AUX Mode” (page 18) is set to OFF, the
auxiliary source is not displayed.
• VISUALIZER (VISUAL.) is not displayed when the setting of “Setting
the VISUALIZER Mode Display” (page 18) is turned off.
Adjusting the Subwoofer Level
Turning Loudness ON or OFF
Turning Defeat ON or OFF
Adjusting Volume of GUIDE Voice
REAR-1: A rear external monitor can be connected to AUX
OUT 1 of the optional expansion box (VPE-S431).
REAR-2: A rear external monitor can be connected to AUX
OUT 2 of the optional expansion box (VPE-S431)
01GB00VPAB222R.book Page 12 Monday, January 23, 2006 4:24 AM