AMX MIO R-1 AUDIO FG147-04 - Manual (Page 12)

Programming The MIO R-1 AUDIO
8 MIO R-1 AUDIO
Debug Mode
Pressing button "4" on the remote toggles development mode between ON and OFF. The display
indicates the selected mode. In development mode, the display shows the IR code assigned to buttons
when pressed.
This mode is useful to the programmer when determining what IR codes are associated to each mode.
Battery Type
Pressing button "6" on the remote toggles the battery type between Normal and Recharge. The display
indicates the selected type. The type of battery in the MIO R-1 AUDIO dictates the battery type you need
to set.
LED Awake Brightness
Pressing button "7" on the remote toggles the Power LED brightness mode from LOW to MED and then
HIGH. The display indicates the selected mode.
Sleep Brightness
Pressing button "8" on the remote toggles the Sleep brightness mode from OFF to LOW and then MED.
The Sleep brightness is the state the MIO R-1 AUDIO assumes while in the charging cradle.
Setting The IR Frequency
The MIO R-1 AUDIO is set to the IR frequency 38KHz by default. You need to utilize the IRMODE
Serial Command to change the frequency to 455KHz. To set the frequency to 455KHz:
1. Establish a HyperTerminal session with your device.
2. Send "IRMODE 455" to the device.
3. Close the HyperTerminal session.
The command, "IRMODE 38" switches the device back to 38KHz.