AMX MIO R-1 AUDIO FG147-04 - Manual (Page 24)

Using the MIO R-1 AUDIO Remote
20 MIO R-1 AUDIO
Zone Grouping
In this state, zones can be "grouped" together and controlled as a single zone. Press the "GRP" button to enter
"Group Mode".
Adding a Zone To a Group
1. Press the "GRP" button to enter "Group Mode".
2. Key in zone # to add to group.
3. Press ENTER (to exit Group Mode).
Grouping All Zones
1. Press the "GRP" button to enter "Group Mode".
2. Key in "99".
3. Press ENTER (to exit Group Mode).
Un-Grouping All Zones
1. Press the "GRP" button to enter "Group Mode".
2. Key in "00".
3. Press ENTER (to exit Group Mode).
Group Volume Control
Adjusting Volume for the entire Group can be made at any time, as follows:
1. Press the "GRP" button to enter "Group Mode".
2. Volume UP / DOWN as required (NAV Up/Down buttons).
3. Press ENTER (to exit Group Mode).
To bring all zones to the same volume level (after individual zone adjustments have been made), enter Zone
Grouping mode and decrease the volume to 0db, then increase the volume to desired level.
FIG. 8 Group (GRP) button
Group (GRP) button
The zone from which zone grouping is being administered, is assumed to be the 1st
zone in the grouping. It should, therefore, not be added to the grouping.
All zones will have the volume increased/decreased by the adjustment being made.