Alpine VPA-B211A - Manual (Page 20)

19
-EN
To activate your TV unit:
To watch a video source, your vehicle must be parked
with the ignition key in the ACC or ON position. To do
this, follow the procedure below.
1.Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2.Keep pushing the foot brake and release the parking
brake once then engage it again.
3.When the parking brake is engaged for the second
time, release the foot brake.
• For automatic transmission vehicles, place the
transmission lever in the Park position.
Now, the locking system for the TV mode operation has
been released. Engaging the parking brake can
reactivate the TV mode, as long as the car's ignition has
not been turned off. It is not necessary to repeat
the above procedure (1 through 3), of “To activate your
TV unit.”
Each time the ignition is turned OFF, perform the
procedure of “To activate your TV unit.”
• If you try to activate the TV unit while driving, the
display will show the warning-PICTURE OFF FOR
YOUR SAFETY.
1
Press SOURCE to activate the AUX mode.
2
Press BAND/PRESET to select the TV mode.
AUX-1
→ TV → AUX-1
When VPE-S431 is connected:
AUX-1
→ AUX-2 → TV → AUX-1
3
Press g or f to seek for a channel
downward or upward respectively.
• When using the optional remote control (RUE-4190), TV
Channel can be directly called up with the numeric keypad
of the remote control.
1 While in TV mode, enter the Channel number you
want to call up with the numeric keypad on the
remote control.
The Channel is automatically received after the channel
number is input.
Automatic Memory of Channel
Presets
1
Press :/J/SEARCH.
The auto preset operation starts.
After the completion, memorized channel number
list displays and the first memorized station is
automatically received.
2
To receive a memorized station, press 8 or 9.
Information
In Case of Difficulty
If you encounter a problem, please turn the power off,
then on again. If the unit is still not functioning
normally, please review the items in the following
checklist. This guide will help you isolate the problem if
the unit is at fault. Otherwise, make sure the rest of your
system is properly connected, or then consult your
authorized Alpine dealer.
Basic
No function or display.
• Vehicle’s ignition is off.
- If connected according to the instructions, the unit will
not operate with the vehicle’s ignition off.
• Improper power lead connections.
- Check power lead connections.
• Blown fuse.
- Check the fuse on the battery lead of the unit; replace
with the proper value if necessary.
• Internal micro-computer malfunctioned due to interference
noise, etc.
- Press the RESET switch with a ballpoint pen or other
pointed article.
No sound or unnatural sound.
• Connections are not properly or securely made.
- Check the connections and firmly connect.
Screen not displayed.
• Connections to the DVD, CD player, navigation system are
not securely made.
- Check the connections and firmly connect.
Navigation system inoperative.
• Connections to the navigation system are incorrect.
- Check the connections with the navigation system and
connect the cables correctly and firmly.
Remote control of the rear monitor is inoperative.
• The VPE-S431 is not connected.
- Make sure the VPE-S431 is correctly connected (refer to
“Connections”).
Make sure the cable is not bent excessively.