Monoprice PID 9205 Plug Play Wireless Day and Night Network IP Camera with Audio MPEG4 - Manual (Page 9)

Plug & Play Wireless Day and Night NetworkCamera
9
network switch or router, as shown in Figure 2-4. By default the IP CAM is configured
to use the DHCP function and most home/office networks include a DHCP server.
Therefore the IP CAM should connect to the internet immediately. The Internet status
LED will be constant red when the IP CAM is properly connected to the Internet. If the
LED is blinking, please refer to section 3.3-3.5 to try other network settings.
Figure 2-3: IP CAM connection diagram.
Figure 2-4: Connect Ethernet cable to a switch/router.
Second, install the CamView software on a PC/notebook
Insert the installation CD into the CD-ROM drive in your notebook or personal