Alcatel-Lucent OMNISWITCH 6800 - Manual (Page 53)

OmniSwitch 6800 Series Chassis and Hardware Components Power Cords
OmniSwitch 6800 Series Hardware Users Guide June 2007 page 2-27
Note. Chapter 3, “Managing OmniSwitch 6800 Series Stacks,” provides important information on virtual
chassis behavior during and after a boot. Consulting this chapter is strongly recommended for users oper-
ating switches in a stacked configuration.
Power Cords
Because the power cord is the switch’s only disconnect device, it should be plugged into an easily
accessible outlet. In the event that your power cord is lost or damaged, refer to the specifications below.
Specifications
The power cord to be used with 115-Volt configuration is a minimum type SJT (SVT) 18/3, rated at 250
Volts AC, 10 Amps with a maximum length of 15 feet. One end terminates in an IEC 320 attachment plug
and the other end terminates in a NEMA 5-15P plug.
The power cord to be used with 230-Volt configuration is minimum type SJT (SVT) 18/3, rated 250 Volts
AC, 10 Amps with a maximum length of 15 feet. One end terminates in an IEC 320 attachment plug and
the other end terminates as required by the country where it will be installed.
European cords must be Harmonized (HAR) type. Refer to the information below for power plug types by
region:
Power Cord Types
North America NEMA 5-15-P (US), C22.2, No. 42 (Canada)
United Kingdom / Ireland BS 1,363
Europe CEE 7/7
Japan JIS 8,303
Australia AS 3,112
India BS 546
Italy CIE 2,316
Switzerland / Liechtenstein SEV 1011
Denmark / Greenland SRAF 1,962 / D816 / 87
Argentina AR1-10P