Alcatel-Lucent OMNISWITCH 6800 - Manual (Page 73)

OmniSwitch 6800 Series Chassis and Hardware Components Backup Power Supply Components
OmniSwitch 6800 Series Hardware Users Guide June 2007 page 2-47
3 With one hand, grasp the handle at the front of the power supply. Place your other hand under the
power supply casing to support its weight. Carefully insert the rear of the casing into the power supply bay
and slide the power supply back along the chassis alignment guide until its connector meets the chassis
backplane connector.
Inserting the Backup Power Supply
4 Continue sliding the power supply back until the front panel is flush with the rear panel of the chassis.
Do not force the power supply into the bay. Otherwise you can damage the connectors.
5 Tighten the two captive screws, located at the left and right sides of the power supply’s front panel. Be
sure not to overtighten the captive screws. If you use a screwdriver, the torque used to tighten the screws
must not exceed 2.3 foot-pounds.
Tightening the Captive Screws
6 Connect the power supply cord (provided) into an easily accessible power source.
Note. If you are installing multiple backup power supplies in the power shelf, install all remaining units by
repeating steps 1 through 6 for each supply.
Chassis Alignment Guide