Total access 3000 h2tu-c flash upgrade, Figure 48, Total access 3000 h2tu-c flash image screen – ADTRAN HDSL2 User Manual
Page 57
HDSL2 for General Distribution Installation and Maintenance Practice
Control Port Operation
61223HDSL2L2-5B
47
Total Access 3000 H2TU-C Flash Upgrade
Ability to download new firmware for the unit is available via the Total Access H2TU-C Flash
Image screen (
). This feature allows the download and installation of a firmware
upgrade. Any existing provisioning setting will be retained, while new provisioning items will
assume the factory default settings. Prior to installing, the H2TU-C will confirm that the
firmware is correct. When initiated, setup instructions will be displayed on the craft access
terminal.
Figure 48. Total Access 3000 H2TU-C Flash Image Screen
The Download H2TU-C via Y-Modem menu (
) allows the user to initiate a Y-Modem
file transfer from the computer connected to the SCU craft access port to the H2TU-C. This file
is transferred to the SCU and downloaded to the H2TU-C at the SCU craft port baud rate;
therefore, a higher-speed connection to the SCU is recommended (typically 115200 baud) to
reduce file download times. At 115200 baud, a typical flash download to the H2TU-C will take
less than 3 minutes.
NOTE
The file downloaded to the H2TU-C via the SCU should be of the
“.bin” file type only and will be provided for feature enhancements
and additions.
Shelf: 1 Slot: 14 Total Access System 03/01/05 10:59
Unacknowledged Alarms: INFO
Circuit ID:HntsvlALMn0103
Main SW Ver Boot SW Ver Checksum
HTUC Flash Image: A01 01 1234
Software Update
1. Download H2TU-C via Y-Modem
2. Download H2TU-C via TFTP
3. Boot Block Status
Selection: