List of serial commands, Table 6 – Vaisala WAC155 User Manual
Page 37
Chapter 4 ________________________________________________________________ Operation
VAISALA _______________________________________________________________________ 35
discarded. Commands may include parameters and values which are
separated by a space ' '. Only one parameter can be set with a single
command; multiple parameters require multiple commands.
You can repeat the previous command by typing CTRL+P. The
previous command will be brought to the console, but it will not be
automatically executed. You can delete characters with the backspace
key [<=]. Arrow keys are not available for data editing, and tabulator
completion is not supported.
A list of the supported commands is provided in section
List of Serial Commands
The following table provides a list of the serial commands that are
available in the service connection.
Table 6
List of Serial Commands
Command
Description
OPEN
Open the service connection
CLOSE
Close the service connection
HELP
Display the command list
SETDEV
Set the ID of the transmitter
SETMEA
Configure measurement parameters
SETSPD
Configure wind speed computation time period
SETDIR
Configure wind direction computation time period
SETMES
Specify data transmission mode
SETCOM
Configure communication ports
SETALR
Configure sensor stuck supervision functionality
SETHEA
Configure wind sensor heating control
GETHEA
Display the current heating status
SERVICE TIMEOUT
Configure timeout for service connection
GETSET
Display the current settings of the device
ERRS
Display the current error status
INIE
Reset the transmitter to factory default settings
RESET
Reset the transmitter to new settings