Vaisala WAC155 - Manual (Page 47)

Chapter 4 ________________________________________________________________ Operation
VAISALA _______________________________________________________________________ 45
GETSET
The GETSET command will return the current configuration of the
current unit.
GETSET <cr>
Example:
>getset
SETDEV
ID=A1
SETSPD
AVERAGE=3.00
SETDIR
AVERAGE=3.00
…
HELP
The HELP command displays a list of the supported commands.
HELP<cr>
Example:
>help
CLOSE Close service connection
SETDEV Set device ID
SETSPD Speed computation average length
SETDIR Direction computation average length
...
INIE
The INIE command resets the transmitter to factory defaults. Note that
the current configuration settings will be lost. Before using the INIE
command, it may be a good idea to view the current settings using the
GETSET command , and record the output.
After using this command, you have to use the RESET command to
take the factory defaults into use, and re-open the service connection
with the OPEN command.
INIE <cr>