AMETEK 1995L Micro-Set PLS - Manual (Page 17)

13 Installation and Maintenance Manual
Chapter 3: Programming
The enable/disable feature is programmed as follows:
A) Unit must be in the “Program” mode.
B) Depress
CIR# 380 Enables the Outputs.
CIR# 381 Disables the Outputs.
CIR# (380 or 381) - ENT -
.
NOTE: If you try to disable the outputs in the Run mode, the unit will display “EEE”.
3.18: Enable/Disable Outputs
During setup, the outputs may be enabled or disabled. When outputs are selected to be disabled, the
status LEDs and the relays will be OFF. The unit must be in the Program mode to disable the outputs;
as soon as the unit is switched to the Run mode, the outputs will be enabled.