Summers 30' Superroller - Manual (Page 16)

SECTION 2 - ASSEMBLY
1
1
2
2
A A
B B
-40 3/15/2007 9LR3042.iam/
8P4215
NOTE: LOCATION OF H STAMPING TO BE TOWARDS THE CENTER OF MACHINE
2-6
Roller Installation
R1. Clean Roller Pivot shafts
R2. Elevate the wing frame and position roller under it. The wing frame will be free to pivot.
Block the wing frame to control unexpected movement. Center roller in the wing frame and
slowly lower the wing as shown in Figure 3. CAUTION: Each roller weighs 4285 lbs., block
to prevent unexpected movement. Be careful when moving the rollers, use extreme cau-
tion when centering the rollers and lifting the wing frames. NOTE: An H has been stamped
onto one end of each roller, position this H to the center of the Machine.
Figure 3