Summers 30' Superroller - Manual (Page 18)

SECTION 2 - ASSEMBLY
-70 8/27/2014 9LR3042.iam/
21 1/2"
21 1/2"
8P6110
8X0044
7/16" X 3-1/2"
8D0350
3/4"X4-1/16"X10"
8X0234
7/16" LNUT
8X0260
3/4" N
8T4100
8T3640
8P6105
8X0072
1/2" X 3-3/4"
8X0242
NY-LOCK 1/2" N
8K1105S
8K7042
8P6110
PRE-ASSEMBLE
BEFORE
ATTACHING TO
CENTER FRAME
TOWARDS
TRACTOR
8P6110S
8X0306
3/4" LW
8K7123
8X0133
7/8 X 3"
8X0307
7/8" LW
8X0268
7/8" N
Wheel and Pivot Arm Intallation.
WP1. Locate 8P6110 and 8P6110S and install hub assemblies as shown in Figure 5. Secure hub
assemblies with the hardware shown.
WP2. Install two wheels on each assembly. Torque wheel nuts to 240 FT-LB
WP3. Install two 8T4100 as shown in figure. Loosely attach to the frame with 8D0350, lock wash-
ers and nuts. This will allow them to be moved and positioned when attached the pivot
arms.
WP4. Position the Pivot Arm Assembly and wheels as shown in figure. The Center of the arm
should be positioned to the dimension shown.
WP5. Install pin 8T3640, align hole in pin with the hole in 8T4100 and secure with the hardware
shown.
WP6. Tighten hardware that was installed in WP3. (Make sure the center of the arm is positioned
to the dimension shown in Figure 5.)
WP7. Repeat the above steps for the other Pivot Arm. Refer to the drawing to ensure the proper
pivot arm is installed in the correct location.
WP8 Loosely install two 8P6215 in the locations shown in Figure 6, secure with the hardware
shown.
2-8
Figure 5