Kenwood K-323-BK - Manual (Page 37)

37
English
Ad
vanc
ed oper
ations
Setting Auto Power Save
(A.P.S. SET)
A.P.S. stands for Auto Power Save, which is the function
that switches this unit OFF when it has not been
controlled for more than 30 minutes while its power is
ON and the CD and other inputs are in stop mode.
1
Enter the setup mode.
Press [MODE].
2
Select "A.P.S. SET".
Press [ G]/[H] to select,
then press [ENTER].
3
Set the A.P.S. mode to ON/OFF.
Press [ G]/[H] to select,
then press [ENTER].
A.P.S. ON
A.P.S. OFF
A.P.S. mode is OFF.
A.P.S. mode is ON.
When the setting completes, "COMPLETE" is displayed
and the unit exits the setup mode automatically.
lights when A.P.S. is set to ON.
When the A.P.S. mode is ON...
A.P.S. is activated when this unit is in either
condition below.
When the input source is TUNER, AUX, D.AUDIO or
DIGITAL IN, the volume level is 0 and no button has
been pressed for 30 minutes.
When the input source is CD or USB, the CD player or
USB device is in stop mode and no button has been
pressed for 30 minutes.
■
•
•
Adjusting the recording output
level (Rec Out LEVEL)
If the audio recorded on the component connected
to the [REC OUT] connector is distorted or too low,
adjust the recording output level.
1
Select the input source to be output
at the recording output.
2
Enter the setup mode.
Press [MODE].
3
Select "RecOut LEVEL".
Press [ G]/[H] to select,
then press [ENTER].
4
Adjust the recording output level.
Press [ G]/[H] to select,
then press [ENTER].
The recording level can be adjusted as desired in
the range between –2 and +2.
Display when the recording output level is "+2".
When the setting completes, "COMPLETE" is
displayed and the unit exits the setup mode
automatically.