Kenwood KDC-BT92SD - Manual (Page 26)

51 | KDC-BT92SD English | 52
Resetting of DTA Settings
You can reset the DTA-compensated values to the
factory settings.
1 Select the source
Pressing the [SRC] button repeatedly switches
source.
Select a source other than “STANDBY”.
✍ SRC Select mode 2: Press the [SRC] button and
then turn the [VOL] knob. To determine the
selected source, press the [VOL] knob.
2 Enter Audio Control mode
Press the [VOL] knob.
3 Enter Reset DTA Setting mode
Turn the [VOL] knob and press it when the
desired item is displayed.
Select “Pro Setup”
> “DTA Settings” > “Reset
DTA Setting”.
4 Reset the DTA settings
Turn the [VOL] knob to select “YES”, and then
press the [VOL] knob.
Audio Preset Memory
Registering the value setup by Sound Control.
1 Setup Sound Control
Refer to the following operations to setup the
Sound Control.
- Manual Equalizer Control (page 45)
- Car Type Selection (page 47)
- Speaker Setting (page 47)
- X’Over Setting (page 48)
- Listening Position Selection (page 49)
- Listening Position Fine Adjustments (page 49)
- Channel Level Fine Adjustments (page 50)
2 Enter Audio preset memory mode
Turn the [VOL] knob and press it when the
desired item is displayed.
Select “Pro Setup”
> “Preset” > “Memory”.
3 Select the number to put in the memory
Turn the [VOL] knob and press it when the
desired item is displayed.
Select a preset number.
4 Turn the [VOL] knob and press it when the
desired item is displayed.
Select “YES”.
“Memory Completed” is displayed.
5 Exit Audio Control mode
Press the [MENU] button for at least 1 second.
⁄
• Register 2 patterns of Audio Preset Memory.
• Preset number “1”:
When you press the Reset, all the sources will be the
setting value which is registered.
• Preset number “1” and “2”:
The memory cannot be erased by the Reset button.
• This function cannot be registered when the iPod
Equalizer set in <Preset Equalizer curve Select> (page 44) .
Audio Preset Recall
Recalling the sound setup registered by <Audio
Preset Memory> (page 51) .
1 Select the source
Pressing the [SRC] button repeatedly switches
source.
Select a source other than “STANDBY”.
✍ SRC Select mode 2: Press the [SRC] button and
then turn the [VOL] knob. To determine the
selected source, press the [VOL] knob.
2 Enter Audio preset recall mode
Turn the [VOL] knob and press it when the
desired item is displayed.
Select “Pro Setup”
> “Preset” > “Recall”.
3 Select the number to recall in the memory
Turn the [VOL] knob and press it when the
desired item is displayed.
Select preset number.
4 Turn the [VOL] knob and press it when the
desired item is displayed.
Select “YES”.
“Recall Completed” is displayed.
5 Exit Audio Control mode
Press the [MENU] button for at least 1 second.
⁄
• The “User” of <Preset Equalizer curve Select> (page 44) is
changed to the value which was recalled.
• The Equalizer curve is changed to the value which was
recalled by the selected source.
DSP Setup