Kenwood MGR-E8-B - Manual (Page 36)

MGR-E8 36
Changing the Recording Settings
Item Setting Setting overview
Int.
Mic Ex
t. M
ic
Li
ne
Mic Sync Rec OFF*/ON
Recording starts in synchronism with the
start of microphone sound input. Recording
pauses when no sound has been input for
2 seconds.
This item is enabled when [MIC REC LEVEL]
is set to AUTO.
● ●
Analogue limiter OFF*/ON
When high-level sound is input suddenly
while this item is set to ON, the recording
level is automatically adjusted to prevent
distortion of the recorded audio.
This item is enabled when [MIC REC LEVEL] is
set to MANUAL.
● ●
Low-cut filter OFF*/ON
Set to ON to reduce noise from the air
conditioner or blowing wind by cutting off
the low frequencies.
● ●
Delay Rec OFF*/5sec/10sec/30sec
Set the delay time reserved before actual
recording starts after [REC] is pressed. This
is convenient when preparation is required
before starting recording, for example for
checking the musical instruments, etc.
● ● ●
Line auto divide OFF*/ON
When this item is ON, recording on a new
file begins when no sound has been input for
2 seconds.
●
Auto divide level High/Mid*/Low
Set the level for detecting the beginning
of music.
●
(* : Factory setting)
• Since the <Mic Sync Rec> and <Line auto divide> recordings start after the
start of audio is detected, the initial section of the audio may not be recorded.
To prevent this, do not use these settings for important recordings. It is
recommended to record a single file and divided it later. (page 40)
B60-5825-08_00_MGR-E8(E)_English_1AJ6P1P0109--(XE0).indd 36 B60-5825-08_00_MGR-E8(E)_English_1AJ6P1P0109--(XE0).indd 36 10/08/04 13:48 10/08/04 13:48